Have you considered EPax? They sometimes offer refurbs at price points that may fit your budget.

Not sure if all their components are US sourced, but they are US based and offer real customer support.

Maybe you have too much squish?

Here are some things to try:

• make sure you have properly cleaned the new bed; ipa or dish soap. I have gone so far as lightly sand my new pei sheets with high grit sand paper to improve adhesion. Try the list below before considering sanding.
• bed temp: as you mentioned a cooler bed temp may improve corner curling. 50c or just yolo it and turn it off
• sounds like you’re printing with PLA: maybe slightly lower your hot end temp.
• mouse ears at the corners may help keep them from curling.
• make sure your printer isn’t catching a cool breeze.

FYI. The Bambu P1P is currently going for $599 USD. It’s a core xy , with impressive print speeds, with an upgrade path to a proven multi materials solution.

Since you are placing it near an AC, you’ll need to print the side panels to partially enclose it. Lots of community upgrades available.

Good luck.

🫡

I have a Prusa Mini original launch edition, and can’t say enough good things about the printer - we run a low volume Etsy shop with the Mini and it’s been a reliable work horse.

One thing I learned that is not on your list is that Prusa has great customer support; live people that you can talk to on your questions or issues. This in my opinion separates Prusa from most other consumer printer companies.