This blood is flowing through a warped mind.
I’m currently running pfsense, and then mikrotik and ubiquiti switched and ubiquiti AP’s. I’m slowly removing the ubiquiti switches and moving to mikrotik as I’m upgrading to 10gbe. Mikrotik switches have a reputation of being reliable, capable, and cheap-ish. So far I like them. While I love ubiquiti’s single pane of glass approach with the unifi controller, I wanted to get away from that a bit. I work in IT, and most things I encounter don’t have that… And are configured via cli and or web interface. When I built my home network I jumped into ubiquiti for the ease. Now I’m back tracking for more learning.
At that depth, I feel like creaking and cracking is probably common. However, I don’t think there would be any spraying as an indicator. Based on this tweet I saw earlier.
Incase anyone is wondering… Little clip of an implosion
RIP to those who parished. I think most can take solace knowing that if it turns out to be true that it was an implosion, it would have been instant, and the occupants likely felt nothing. .
I think it’s as equally important to remember; A backup is not back up… Until you’ve restored from it.
Test your backups, folks.
There’s probably others. Just a quick off the top of my head list.
How do you like vyos? I had looked into it, and it seemed a little cumbersome last time I looked at it. I believe it’s entirely cli? I suppose that’s not a bad thing, but sometimes a gui is nice.
My first printer was a creality cr6 (kickstarter edition), and it’s been absolutely fantastic. I use my printer to solve problems mostly by designing my own parts for things. My printers really are tools to me. My cr6 doesn’t get used a lot, but I turn it on, run the auto level, and hit print. I’ve printed roughly 2000 hours with it, and I’ve had one jam, and zero failed prints (I’ve stopped a couple for various reasons, but I’ve never walked in to find a spaghetti mess). I upgraded to the community firmware, a dual drive extruder, and capricorn. Also, I print almost exclusively in PLA.
My second printer is a kingroon kp3s. I’ve printed very few parts with it. I got it as a toy, and plan to install klipper and just be able to print fast. I like the small for factor, direct drive, and linear rails. It’s a decent printer, but it’s not as “easy” as my cr6 (no ABL, and my bed seems to have a high spot right in the middle). The prints I’ve printed for testing are small, and the quality has been really good. I just haven’t had a lot of time to play with it and really dial it in.
All this said… I’d by a mk4 in a split second for my use case. Again, as a tool that I turn on every few months, prusa is a known workhorse. My only complaint with my cr6 is it’s slow… And the mk4 would take care of that.