A thin layer of glue stick kept petg from bonding to glass for me, but a nice thick layer of G10 is better as long as you heat soak it before printing. I roughed mine up with some sandpaper and haven’t had any issues. Just remember good ppe when working with fiberglass.
Especially odd to mention the availability of a ramp under a picture of her motioning to stairs.
then he said
No, not that one. The bad one
folding stool
I thought that only happened to cats
If lemmy was the entire EU voting block the world would be a very different place. It’s not encouraged here, but here is not the entire EU.
in other news, Charelston PD announces their new MH-139A helicopter
In USA I usually get Printed solid’s Jesse and 3D Printing Canada’s Budget PLA. I also pick up a couple rolls of Inland any time I’m by my local Microcenter
Filament sourcing is pretty region specific. Where are you buying from?
This might’ve hurt too.
easy peasy. just lift the 100 kilo chunk of iron with some tongs. /s
I also always have a sharpie on me and often use it to fix the missing labels on these pumps.
Surgeons already aren’t allowed to put non FDA approved things in you. You would go to a tattoo/piercing shop for that sort of thing.
Heavy on the “peer”, light on the “review”
You’re one of today’s lucky 10,000
When I make them I do bisquick biscuits with a handful of shredded cheddar. A little melted butter and italian seasoning tops it off.
Hextraction seems pretty cool.
Blaggie