I didn’t on my FlashForge CreatorPro unless I had an issue, but I do on my BambuLab X1C - but that’s because it’s a fully automated process using the built in lidar.

I would contact their customer support, it’s likely they’ll send you a new roll, and hopefully it will help them improve quality knowing they shipped some bad ones.

I would contact their customer support, it’s likely they’ll send you a new roll, and hopefully it will help them improve quality knowing they shipped some bad ones.

I would contact their customer support, is likely they’ll send you a new roll, and hopefully it will help them improve quality knowing they shipped some bad ones.

Same here, syncthing is fantastic and I use it for all kinds of stuff - including backing up phone media.

Not this this helps you, but it’s been running solid here since upgrading. I’d take a look at the logs and see what’s going on, myself.

I never had much luck with the layout editors, so I just hand edit the JSON. Here’s part of my main dashboard (it scrolls on for a ways, but this much was already a big screenshot).

I use Manjaro, but I run it like vanilla Arch (for example pacman/yay and not pamac). I find this to be a sweet spot for me - rolling releases are so incredibly nice, and Manjaro being slightly slower than Arch is good from a stability standpoint in my experience.

I use ZFS all over the place, including the root storage pool on my home server, which has overall been a great experience with systemd-boot.

Doesn’t help you, but I haven’t seen this issue - I recently upgraded to 2023.6.1.

i3 is what I’ve been using the past few years. I’ve tried others, but I always end back up with i3 as I’ve found nothing else to be as simple and efficient for my workflow, with 12 workspaces across 2 monitors.