Does anyone know the current state for re-flashing Inovelli Blue switches to Thread? I haven’t been paying attention the last year so I don’t know if they released that or if it works reliably. I did try looking through the community pages without finding anything definite (plus that might not include any actual experience trying it)
I recently saw a couple new Thread devices, so maybe it’s time to start using that. My entire Zigbee network was intended to be flashable to Thread: all I have is SkyConnect and some Inovelli Blue switches. More importantly, that should be a good foundation for a strong mesh to support other devices (and I don’t have a reason for a strong Zigbee mesh). I know SkyConnect multi-protocol didn’t work out but I believe reflashing to Thread is fine. I know Inovelli Blue can’t be reflashed over the air, but that’s ok. Is there Thread firmware and what are your experiences with it?
Unfortunately this will no longer be possible with the mg21 chip used in the blue switches. See Eric’s post linked below:
https://community.inovelli.com/t/zigbee-matter-motion-switch-project-linus-blue-series/10904/439?u=quaffs.cherub_0t
Bummer, but thanks for finding that update. It was always the risk.
I guess it means I won’t try Thread until get some switches or something to support a third iot mesh